Bulletproof Si is a part of Cutting Edge Solutions Advanced Molecular Family. Bulletproof Si provides silicon in a form (SiO2) that can be utilized in essentially any fertilizer regiment, and since Bulletproof SI is formulated without potassium, application flexibility is even greater. The silicon form (SiO2) has shown to increase agricultural production, yield, strengthen plants, promote resistance to stressors like heat, cold, drought, lodging, accelerate mitosis, and even helps promote an advantageous upright stature which leads to favorable exposure of leaves to light. 

Bulletproof Si has additional natural components including amino acids and Ascophyllum nodosum, facilitating an enhanced uptake, translocation and effectiveness. Bulletproof Si is designed to enhance growth and leaf production in young plants, and can provide mechanical protection in the epidermal root cells, acting as a barrier between the roots and pathogens or parasitic invasions. Bulletproof Si is recommended for use with all Cutting Edge Solutions products, as well as with other commercial hydroponic nutrients. 

Guaranteed Analysis 

CONTAINS NON-PLANT FOOD INGREDIENT: 

5% Silicone Dioxide (Si02) derived from Sodium Silicate 

Bulletproof Si should be applied to roots and leaves during all stages of growth. Use lighter solutions of Bulletproof Si ® for young plants, perennials, and during foliar application. Higher strength solutions are best suited for fast growing annuals, during both vegetative growth and fruiting/flowering.

**NOTE** A strong aroma similar to ammonia is normal in Bulletproof Si. The specialty enzymes used in the formula produce a sour, almost acetic smell. Always shake very well before use. 

Directions For Use: Bulletproof Si is a highly concentrated solution. Never mix undiluted concentrates as this may result in nutrient lock-up. Add each nutrient separately to water and aerate reservoir regularly. Apply Bulletproof Si to water before any other nutrients. Shake well and measure carefully using a milliliter measuring cup. If adding to an already mixed reservoir, ensure Bulletproof Si is diluted in fresh water before adding to fertilizer solution. Bulletproof Si ® is strongly alkaline and will raise nutrient solution pH. After nutrients are mixed in water, adjust ph to 5.5-6.5. Monitor ppm/EC and pH in reservoir and top off with fresh water as needed. Reservoir temperature should be 60-68 degrees F. Do not store product in direct sunlight. Do not freeze. Mild Solutions Mix 1 ml Bulletproof Si ® per gallon of water Higher Strength 1 to 2.5 ml/gallon per gallon of water Maximum Strength 2.5 to 4 ml/gallon per gallon of water