TrolMaster Sensor Board for Aqua-X only

SKU: AMP-2

109.25 109.25 USD 109.25

109.25

The AMP-2 module connects the Aqua-x to a set of precision pH / EC & temperature probes to constantly measure the pH / EC & temperature of the water being sampled.

    This combination does not exist.


    TrolMaster Sensor Board for Aqua-X only

    The AMP-2 module connects the Aqua-x to a set of precision pH / EC & temperature probes to constantly measure the pH / EC & temperature of the water being sampled. The AMP-2 works with the TrolMaster PCT-1&2 and the PPH-1&2 probes. Once connected to the Aqua-x, the AMP-2 will display the sensor data on the Aqua-x and on the APP. The minimum and maximum “limits” can be set on the Aqua-x providing 24/7 notification of pH / EC or temperatures that are out of limits.

    Features

    • Simple to use DIN Type Bracket for Easy Installation
    • BNC Terminal (left) allows Direct Connection to pH Sensor
    • Mini DIN Terminal (right) allows Direct Connection to EC/Temp Sensor
    • Mini DIN Terminal (middle) allows Direct Connection to Aqua-X Controller
    Package Content
    • 1 x Sensor Board
    • 1 x 2.5-Meter Long Signal Cable 

    Working Environments:  Temperature 32-122°F, Humidity=90%

    Installation

    Mount the Sensor Board near pH Sensor and EC/Temp Sensor in the Aqua-X Control System. Use two screws to mount the Sensor Board on the wall. 
    Operation Instructions


    1. Connecting to Aqua-X


    Use a male-to-male signal cable to connect the Sensor Board to the Aqua-X Controller. Plug the min-DIN cable connector of the signal cable into the SENSOR BOARD terminal on the bottom of the Aqua-X Controller. Then plug the opposite mini-DIN cable connector into the SYSTEM terminal (middle) on the bottom of the Sensor board.


    2. Connecting to pH Sensor


    Plug the BNC connector of the pH Sensor into the pH SENSOR port (BNC Terminal) on the bottom of SENSOR BOARD. Rotate the BNC connector until it's stuck by the BNC Terminal in place.

    3. Connecting to EC/Temp Sensor


    Plug the mini-DIK connector of the EC/Temp Sensor into the EC/TEMP SENSOR port (mini-DIN Terminal) on the bottom of SENSOR BOARD.

    Weight (lbs)0.49
    Length (in)6.3
    Width (in)3.39
    Height (in)3.39
    Barcode6970207970588